PRECISION METERING PUMP SYSTEMS - AIR OPERATED, NEMA BOX MOUNTED

 

These "quick install" cost effective Centralized Lubrication Systems are pre-assembled with compatible components to minimize specification, purchasing and installation time. The automatic lubrication systems operate on a 120V, 60Hz 1Ph electrical supply for the motor. The systems are sized to meet most lubrication requirements where a compressed air supply is not available. Each pump outlet is independently and externally adjustable 0 to 0.012 cu. in. (0 to 0.197 cu. cm) by using a fine micrometer thread 0.025 (.572 mm) pitch adjustment. Each pump outlet will actuate once per minute of motor run time.

STANDARD MATERIALS:
  • Aluminum, Brass, Steel, transparent polymer
  • Buna N & Viton seals
  • Painted Steel Nema Type 12 and 13 Box
  • For additional component information see Bulletins F1837-2, F357-7, F1867-1 and F1867-2
OPERATING CONDITIONS:
  • Maximum operating temperature up to 120°F (48.9°C)
  • Minimum operating temperature 0°F (-17.7°C) oil
  • Minimum operating temperature 32°F (0°C), grease
  • Maximum output pressure up to 50 PSIG (345 kPa)
  • 120V, 60Hz, 4 W

 

 

LDI_Dwg_Precision Metering Pump Systems_Motor Operated_NEMA Box Mounted

 

 

FOR OIL APPLICATION
CAT
NO.
RES
CAP
NO. OF
FEEDS
W x H O.A.
DEPTH
PMP640-01 1 Qt. 1 7.00"
x
16.00"
6.38"
PMP640-02 1 Qt. 2
PMP640-03 1 Qt. 3
PMP640-04 1 Qt. 4
PMP660-01 0.5 Gal 1 7.00"
x
18.12"
PMP660-02 0.5 Gal 2
PMP660-03 0.5 Gal 3
PMP660-04 0.5 Gal 4
*FOR GREASE APPLICATION
CAT
NO.
RES
CAP
NO. OF
FEEDS
W x H O.A.
DEPTH
PMP630-01 75 Cu. In. 1 7.00"
x
17.80"
6.56"
PMP630-02 75 Cu. In. 2
PMP630-03 75 Cu. In. 3
PMP630-04 75 Cu. In. 4
PMP650-01 168 Cu. In. 1 7.00"
x
22.55"
PMP650-02 168 Cu. In. 2
PMP650-03 168 Cu. In. 3
PMP650-04 168 Cu. In. 4
*Caution: When using grease both the PMP100 Series and PMP200 Series Precision Metering Pumps are capable of dispensing nearly all types and grades of grease used in most general industrial, indoor or controlled temperature applications of 32°F (0°C) or above. The combination of higher viscosities, ambient temperatures lower than 32°F (0°C), excessively long runs of output feed lines, along with the type and use of smaller inside diameter feed lines, will have an effect on the feed rate and output capabilities of these pumps.